If your ATV won’t start solenoid clicks, it’s likely due to a problem with the starter solenoid. This is a common issue with ATVs and one that is relatively easy to fix.
In this blog post, we’ll walk you through the process of diagnosing and fixing a starter solenoid issue on an ATV. We’ll also provide some tips on how to prevent this problem from happening in the future.
Why My ATV Won’t Start Solenoid Clicks?
There are a few reasons why your ATV may not be starting, even if the solenoid is clicking. The most common reason is that the battery may be dead or too weak to turn over the engine. Another possibility is that there is a problem with the electrical connection between the solenoid and the starter. Finally, the starter itself may be faulty.
Check the Battery
If your ATV won’t start and you hear a clicking noise, it’s likely that the battery is the issue. You can check the battery by opening up the hood and looking at it. If the battery is dead, you’ll need to replace it.
Check the Starter Solenoid
If your ATV won’t start and you hear a clicking noise, it’s likely that the starter solenoid is the problem. The starter solenoid is a small switch that controls the flow of electricity to the starter motor. If it’s not working properly, it can prevent the starter motor from getting the power it needs to start the engine.
To test the starter solenoid, first disconnect the negative battery cable. Then remove the bolts that hold the solenoid in place and pull it off. Use a multimeter to test for continuity between the two terminals on the solenoid. If there is no continuity, then the solenoid needs to be replaced.
Check the Fuses
If your ATV won’t start and you hear a clicking noise, you should first check the fuses. If any of the fuses are blown, that could be the reason why your ATV won’t start. Replacing the blown fuse or fuses should fix the problem and get your ATV up and running again.
Check the Spark Plug
If your ATV won’t start and you hear a clicking noise, the issue is likely with the spark plug. To check the spark plug, remove it from the engine and inspect it. If the spark plug is fouled or damaged, it will need to be replaced.
Try Jumpstarting the ATV
If your ATV won’t start and you hear a clicking noise, it’s likely that the solenoid is the culprit. The solenoid is an electromagnetic switch that controls the flow of electricity to the starter motor. If the solenoid is defective, it may click when you turn the key but not engage the starter motor.
To jumpstart the ATV, you’ll need another vehicle with a working battery. Park the two vehicles close together and connect their batteries with jumper cables. Make sure that the positive (red) terminal on one battery is connected to the positive terminal on the other battery, and likewise for the negative (black) terminals.
Once the batteries are connected, start the engine on the working vehicle and let it run for a few minutes. Then try starting your ATV. If it still doesn’t start, there may be another issue at play and you’ll need to consult a mechanic.
Conclusion
If your ATV won’t start solenoid clicks, it’s likely that the problem is with the solenoid. This is a relatively easy problem to fix on your own.
But if you’re not comfortable working with electrical components, it’s best to take your ATV to a mechanic. With a little troubleshooting, you should be able to get your ATV up and running in no time.
source
